Gold Member Since 2010
Audited Supplier

Zhangjiagang Chuangpu Machinery Co., Ltd.

Milking Machine, Milk Can, Milk Claw manufacturer / supplier in China, offering Electric Motor Driven Bucket Milking Machine Milking 3 Cows, Automatic Bucket Milking Machine Milk Sucking Machine for Two Cows Milking, Cow Farm Milking Machine Pneumatic Pulsator and so on.

(/ )

Supplier Homepage Company Show

Video

Piston type milking machine operation

Category: Product Introduction
Tags: milking machine,mobile milking machine

This video to introduce how to operation the milking machine: Operation 1)Start Power Please check the rotating parts whether have the lubrication oil before strat;check all the power connect whether according to figure 8 and figure 9. 2)Check air pressure after start for ...

This video to introduce how to operation the milking machine:
Operation
1)Start Power Please check the rotating parts whether have the lubrication oil before strat;check all the power connect whether according to figure 8 and figure 9.

2)Check air pressure after start for 2-3 min,check every part is normal and whether working pressure is 0.04Mpa-0.045Mpa that will displayed on the vacuum meter.

3)Preparing please check and wash nipple with warm water, massage the nipple 2-3 times, then connect the milk shell group to start after confirm without mammitis.

4)Install Milk Shell Before installing the milk cup group, the milker should stand in the one side of cow, the left hand takes the milk cup group reversed (the plugs of clawpiece is up, the clasps of milk cup is down), underneath the cow breast, at the same time, the right hand rapidly put the milk cup on the one by one, the vacuum degree suck the nipple, milking starts. As Figure 4 shows.

5)Milk Flow Control Milking should be under the normal vacuum degree 0.04-0.05Mpa. In the process of milking, the milker should observe the milk flow in the transparent pipe fixed below the milk cup. When the milk flow is reducing, the milker should massage the udder with hand, but, when the milk flow stops, the milker should hold the milking claw in one hand, at the same time, extrude the entrance of the milk cup inner sheath on the udder with another hand, to let the atmosphere enter, then separate the milk cup from the nipple rapidly one by one.As Figure 5 shows, the process of milking ends.

6)Evacuated Milk Cup After milking , first, you should move out the fresh milk from the milk bucket and covered in time; second ,you should insert the milk cup group in the clean water, make the milking machine work, wash out until the milk cup groupware, the milk tube, the milk bucket are clean. Then put them in the clean water again and add the ration disinfectant in water. Repeat the above action

more